Using Go1 Edu robot dog by Unitree

Safety guidelines

This robot requires an induciton before you use it for the first time. If you have not completed this induction, please contact Rohit Ramesh Thampy on slack

What is it?

The Go1 Edu robot dog (otherwise known as a quadruped) is an agile, 4 legged robotic platform.

Go1_cover_photo.jpg

What can it do?

Since it is a legged robot, the Go1 comes with some sophesticated control algorithms built-in, that allows it to balance itself and walk around.

Without any modifications, the Go1 robot dog is capable of doing basic collision avoidance using its onboard stereo cameras. This version also comes with a 2D Lidar, and when that is attached to the robot, it is cabable of doing autonomous navigation.

Since this is a robotic platform, other sensor payloads or hardware can be interfaced with it to extend its capability.

Getting started

The startup and shutdown procedures for the Go1 are covered in more detail in the induction, therefore please ensure to book and attend the induction before using this robot.

Starting up

Ensure that the Go1 is placed on a flat and levelled surface. The robot's abdominal support pad should be flat on the ground and the body should not be tilted. The robot's startup position should look like the images below.

Go1_start_up_position.jpg

Go1_start_up_top_view.jpg

Power on

Shutting down

Ensure that the robot is standing still. If it is in motion, bring it to a stop. Once the robot is standing still press and hold the L2 button. While holding the L2 button, press down on the A button twice and then press down on the B button. Now you can let go of the L2 button.

The short version of this instruciton is HOLD L2 + A + A + B RELEASE L2. The robot dog should now be laying on the floor similar to the starting position.

Power off

Controlling Go1

The Go1 can be controlled using the remote control that comes with it, through its SDK and using ROS. However, this document will only cover the remote control aspect.

Basic controls using the remote control

Controlling the Go1 using its remote control is covered in more detail in the induciton, therefore please ensure to book and attend the induction before using this robot.

  1. Left stick - Controls the position of the robot, as in you can move it forward, backward, left and right.
  2. Right stick - Controls the orientaiton of the robot, as in yaw, pitch and roll.

All other controls and combination of controls can be found on the remote controller.

Additional Resources

  1. Go1 User Manual
  2. Go1 general risk assessment

Revision #4
Created 9 February 2024 11:25:26 by Rohit Ramesh Thampy
Updated 5 April 2024 17:41:38 by Rohit Ramesh Thampy