How do I use classroom AV?

When you come into the room, you need to:

1. Power on

TheYou will find a 7-inch touch screen panel in every classroom, either on the lectern hasor aon 7"the touchwall panel,near whichthe maylectern.

The screen ill usually be blank to save energy.power Tapwhen itthe room hasn't been used for a while, tap the screen once to wake up the screenscreen.

and

Tap turnthe CCI logo to power on the system again.system.

TheWhen TVsthe andsystem projectorsis powered on, you will powersee up, and the toucha screen will look like this:

From here, you can select your source. Toggle voice lift on/off, set the program audio level, and turn off the system.

2. Put on your microphone

You should aim to clip the microphone about one handspan away from your mouth in a normal resting position, approximately 6-8 inches, somewhere in the middle of your chest, as pictured below.

Loose items: Be careful to remove anything which could make a lot of noise near the microphone, such as earrings that clang with another piece of jewellery and lanyards.

3. Plug in your laptop

AtThere thewill lectern, a USB-C HDMI adapter andbe an HDMI cable areeither pluggedon inthe nextlectern tonear the touch panel.panel, Theor hanging from the TV.

Every room should have a USB-C adapter crimped on the end of the HDMI cable.

Multiple HDMI inputs: Where there is more than 1 HDMI port the left HDMI port is HDMI 1, and the right is HDMI 2.

You should use HDMI 1 by default as this will mirror the signal to the lectern confidence monitor so you can see what's on the TVsscreens behind you. It's also recorded to Panopto for lecture capture.

HDMI 2: If you require the use of HDMI 2 for a document visualiser or similar, please be aware that this will not be recorded by Panopto automatically and needs to be requested in advance.